And does it work?Quote:
Originally Posted by Lazy
Printable View
And does it work?Quote:
Originally Posted by Lazy
no it still failed
Quote:
Originally Posted by Lazy
The steps conclude with:Quote:
Originally Posted by Lazy
Still need help?
Please dont post that you have "tried everything".
Please provide the following info when posting a request for Port Forwarding help.
1. Your LAN IP Address
2. The first two sets (octects) of your WAN IP as displayed by Fantasy Grounds and as displayed by your Router
3. Whether you are using Wired or Wireless (and not both)
4. Confirmation that you have set your Adapter in Network and Sharing Centre to Private
5. Confirmation of what AV you are running and whether you have set any exceptions
6. Post the results of the tracert 8.8.8.8 command (if you have security concerns you can remove this bit once its been responded to)
7. Confirmation as to what you have setup in your Router if changes have been made
If you answer the 7 questions Im sure we can get to the bottom of your configuration.
1. 192.168.1.50
2. Used Port Forwarding to look for internal (192.168.1.50) and external (99.38.116.205)
3. I'm wired
4. Network is set to Private.
5. AV and firewall dose have an exceptions for FG.
6. the tracert 8.8.8.8 command:
1 3 ms <1 ms <1 ms dsldevice.attlocal.net [192.168.1.254]
2 24 ms 29 ms 24 ms 76-230-56-1.lightspeed.livnmi.sbcglobal.net [76.230.56.1]
3 23 ms 23 ms 23 ms 71.151.244.93
4 24 ms 24 ms 24 ms 75.26.64.218
5 25 ms 30 ms 32 ms 12.83.32.181
6 31 ms 31 ms 31 ms gar26.cgcil.ip.att.net [12.122.99.93]
7 32 ms 31 ms 32 ms 12.247.108.6
8 * * * Request timed out.
9 32 ms 32 ms 32 ms 216.239.42.112
10 31 ms 32 ms 32 ms 72.14.237.31
11 31 ms 31 ms 33 ms google-public-dns-a.google.com [8.8.8.8]
7. Port 1802 has been made correctly in my router/modem.
Hopefully these was what you were asking for.
If its still not working then most likely something there is stsill not setup correctly.
Please post a screenshot of: your port forward settings and delete the existing FG firewall rules and create a new one. Port, Incoming, TCP, 1802, always from anywhere.
Attachment 26782
Here the screenshot.
Good stuff. So that screenshot shows that you have defined the FG port requirements/service. Now you need to create a NAT entry/rule that uses that service and applies it to your computers LAN IP.
ok, I'm not too sure on how to do that but I'll google it.
Attachment 26786
Is this it?