They're getting so cheap now that it's not bad to pick one up as a hobby.
I have a 3D printer and mainly use it to print board game stuff.
Printable View
Now if they would just make a 3d painter
There was recently a Kickstarter for the Dragonlock miniatures, with addons for the terrain.
The recommended printer for these is the Creality Ender-3.
Nope, I haven't picked one up yet, but plan to as soon as we move (3-4 months, new home, new town, crappy commute)
Dave
You can pick up an Ender 3 for around $200 if you shop around. It’s amazing the quality of terrain and minis this can turn out (in terms of FDM 3D printing). There’s a couple of small upgrades recommended, the total cost is usually less than $250. Then you’ll need to buy filament - around $20-$25 per KG, which will give you a lot of prints.