Isolate Areas of Maps For Effects

[ransolot]

Not sure if this is the right place to post, so apologies if this is the wrong area.

What I am wondering is if there is a way to isolate just a portion of a map for effects. So let’s say I had a forest map with a river loaded into my assets and wanted to have a full effect of rain on the map but just the water effect on the river, is there a way to do that? Thanks all!

[JohnD]

Apply the Fx, set a mask and then remove the mask where you want the Fx to be seen.

[Moon Wizard]

You can apply a mask for just the water effect to limit it to the river portion of the map.

Regards,
JPG

[LordEntrails]

Click this button, then hold ALT while drawing to reveal a free form area from the mask.
56720

IMO, only challenge with this is it's hard to see what areas you ahve previously removed from the mask.

[ransolot]

Right on. I’ll give it a shot tonight. Thank you!

[LordEntrails]

IMO, only challenge with this is it's hard to see what areas you ahve previously removed from the mask.
To this I've added an idea to the wish list: Idea Informer » Feedback 2.0 (https://fgapp.idea.informer.com/proj/fgapp?ia=140450)

[Zacchaeus]

See video six here https://www.fantasygrounds.com/forums/showthread.php?55797-How-do-I-in-Unity

[ransolot]

Works awesome, thanks everyone!

[Mike Serfass]

To this I've added an idea to the wish list: Idea Informer » Feedback 2.0 (https://fgapp.idea.informer.com/proj/fgapp?ia=140450)

Thanks for that. I added my vote.
I dial up the effect as high as it will go until I'm done with the mask.
That's works only so well, since some of the effects overrun the border (like ocean).
Demarcation would be very helpful.