Ecks
March 16th, 2022, 16:37
When editing an image I ran into a case where a token was showing up as editable on the layer tab. I'm assuming this isn't intended, since normally it doesn't seem like you can select tokens when editing image layers.
To recreate in a new 5E campaign, no extensions:
Open a map (I used BattleMap01 from FG Map Module)
Drop a PC token from CT onto map
Select token and then move it a few spaces
With token still selected, edit the image and go to the layer tab. The token is selected and can be modified: Capture1.JPG (https://www.fantasygrounds.com/forums/attachment.php?attachmentid=52010)
If the token is now moved while in layer editing mode, the layer handles don't move with it: Capture2.JPG (https://www.fantasygrounds.com/forums/attachment.php?attachmentid=52011)
If you click off of the token (to select base image layer), you cannot re-select the token again without repeating the above steps.
FGU v4.1.14
5E 2022-03-01
No extensions
To recreate in a new 5E campaign, no extensions:
Open a map (I used BattleMap01 from FG Map Module)
Drop a PC token from CT onto map
Select token and then move it a few spaces
With token still selected, edit the image and go to the layer tab. The token is selected and can be modified: Capture1.JPG (https://www.fantasygrounds.com/forums/attachment.php?attachmentid=52010)
If the token is now moved while in layer editing mode, the layer handles don't move with it: Capture2.JPG (https://www.fantasygrounds.com/forums/attachment.php?attachmentid=52011)
If you click off of the token (to select base image layer), you cannot re-select the token again without repeating the above steps.
FGU v4.1.14
5E 2022-03-01
No extensions