Sterno
April 26th, 2021, 20:36
The 4.1 info thread has this example for a torch effect.
LIGHT: torch (equivalent to: LIGHT: 20 FFFFF3E1 flicker 25)
The torch preset seems to be Bright 20 ft falloff 25, Dim 40 ft falloff 50.
Based on this, I'm assuming that if you set an effect that doesn't specify the dim light radius (example: LIGHT: 60 FFFFFFFF), it'll just be double whatever the number you did specify was (so it would be the same as if you'd done "LIGHT: 60/120 FFFFFFFF"). Is that correct?
Also, is there any way to specify in effects what the falloff is, or whether or not to cast shadows?
LIGHT: torch (equivalent to: LIGHT: 20 FFFFF3E1 flicker 25)
The torch preset seems to be Bright 20 ft falloff 25, Dim 40 ft falloff 50.
Based on this, I'm assuming that if you set an effect that doesn't specify the dim light radius (example: LIGHT: 60 FFFFFFFF), it'll just be double whatever the number you did specify was (so it would be the same as if you'd done "LIGHT: 60/120 FFFFFFFF"). Is that correct?
Also, is there any way to specify in effects what the falloff is, or whether or not to cast shadows?